1/4" X 2 3/8" Hammer drive anchors C-type BOX

Category: Hardware & Fasteners

SKU: 738287056761

$1.57

In Stock · Midwest Builder & Supply — Iowa & Missouri

← Back to All Products

Product Description

1/4" x 2-3/8" C‑type (hammer‑drive) masonry anchors — steel, zinc‑plated drive sleeves with a pre‑installed steel nail/pin that is driven with a hammer to expand the sleeve and form a permanent anchorage in concrete, brick or block. Typical commercial packaging is a boxed pack (commonly 100/box for this size) and thread/pin length for the 1/4" x 2‑3/8" variant is listed around 3/4"; maximum fixture thickness and drill size guidance is supplied by each manufacturer (install by drilling the recommended pilot hole, insert the anchor, then drive the pin home). These anchors are intended for light‑to‑medium masonry fastening where a tamper‑resistant, permanent anchor is acceptable. (Pack sold as shown; sold each = one box as listed by suppliers.)